Setting up Loopback with new update

I hadn’t opened the Control Center software in a while, so I just yesterday updated to the latest version and drivers, but now I don’t know how to set up the loopback. Previously, I could run my mic through OBS, put FX on, monitor output and use the loopback as my mic for Discord.

The new interface in Control Center confuses me, since it forces desktop audio to route through the loopback, and I can’t mute it going to the loopback without turning off desktop audio.

Been trying to fix this, but no idea at the moment.

Hi Vulpec,

I am unsure of the changes that may have occurred during the update. Have you checked out and settings within the minifuse software?

If you cannot find the answer then you can speak to our technically team:

https://www.arturia.com/fr/support/ask-for-help

Thanks!

I hadn’t updated Arturia Control Center for a long time. After the update, when I tried to record into Ableton Live using loopback, I found that loopback wasn’t working correctly anymore. The problem I’m experiencing is that I can’t control the volume level when trying to monitor the loopback signal. Previously, I could put a Utility on the master channel and adjust the volume of the loopback signal I was listening to. It doesn’t work that way anymore, and in fact, I haven’t found any way to control this volume level at all. Another problem is that the serial number of my MiniFuse 1 product no longer appears in the Control Center; there are just strange graphics where the serial number should be. This last update has been a huge regret for me. I wish I could go back to the version I was using before. I hope you fix these problems as soon as possible. We are waiting for an update.