Macro crash

[resistorman]

Not sure if this is a V issue, but when I connect my hardware to V the Macros stop working until I disconnect and turn it off and on.

PC, Ryzen 5700x, Win 10 Pro 22H2, 6750X video, Tascam Model 12 AI

[joseph.arturia]

Hi resistorman,

Thanks for reaching out on the forum.

Does this still happen after following these steps? https://support.arturia.com/hc/en-us/articles/7751087515548-MiniFreak-V-Connect-your-MiniFreak

[resistorman]

Thanks, looks like I found a bug, it’s only happening on a patch I’m making. I’m custom assigning LFO1 to the VCA. I assigned it on the hardware page 1 assign 1, but there’s no corresponding destination in the mod list in V; VCA is not listed, the other custom destinations all appear to be there. My Freak gets confused when I link, the row shows no assignment and the macros which control the LFO AM and rate stop working.

[LBH]

Hi all.
Welcome to the community @resistorman.

Have a look at this:

[Bug]VCA as destination for modulations doesn't appear on my Minifreak V

Hi there, I am writing because unfortunately I have noticed, after having downloaded the last version of Minifreak V that in the modulations destinations list VCA doesn’t appear. This problem is also quite obvious when uploading the preset Comets, that sounds different in the hardware , where you can hear lfo 2 modulating the VCA, WHILE IN THE Software the modulation doesn’t occur because the mod matrix instead [IMG_20250123_201001] of having VCA as destination has NONE. I have right click…

[resistorman]

Ah… yeah, thanks. I didn’t know causation until I dug in deeper.