Seeking some help from fellow Keylab 61 mkII users regarding the use of these banks.
I want to use the three banks of knobs/sliders/buttons by switching between them using the Part1/2/Live buttons, but somehow seem to be struggling with some basics, even using the default settings.
Here’s what happens.
If I press a Select button, say ‘Select 3’, it toggles on/off as expected, sending the correct CC message. When On, the LED is ON (in blue, according to the default settings). If I then switch Banks, the LED of Select 3 turns off, as this (likely) is the state of this button in this bank.
However, when going back to the previous bank, where I toggled the button to be in the ‘ON’ state previously, the LED remains unlit, so, not reflecting its internal state. Pressing the button again, then sends the off-message, and of course does not light the LED. Pressing it again just works as expected…
Does anyone else also see this behavior? I am using firmware 1.3.1.
Oh, and for some reason the LED of ‘Select 1’ always lights up white when switching banks, regardless of its state. The other buttons go dark…
What am I missing? Any suggestion much appreciated.