Incorrect Clock/Sync

Freak MicroFreak
#1

Hi,
I set the internal clock of the microfreak (single pulse per step) and via Clock OUT with a TS jack I enter the USTA module of the Frap Tools but it does not go in time.
Where am I going wrong?
Thanks

#2

I own neither, but it might be the case that the USTA can’t handle the clock signal. This is from the manual:

shot_fraptools-manual

(can be found here, page 40, 3.2)

Sounds like the USTA won’t accept regular clock signals, therefore can’t handle MicroFreak’s clock output. Since I don’t have the Micro I can’t really tell if you could use the Freak’s CV or Gate outs to run the clock of that sequencer.

#3

I think you are right.

Looking for another solution

Thank you