[Feature/Improvement Request] Additional decimal place for assignable macro values

Freak MiniFreak
#1

It makes little sense that the main parameters in the modulation matrix can be set from 0-100 with one decimal place, while the parameters for the two assignable macros have no decimal places.

A 1:1 mapping is therefore not possible. For this reason, the parameters for the macros should be extended by one decimal place.

#2

HI @PhonicGate

Thanks for the idea, we’ll keep it marked as a feature request so our team are aware.

HTH!

1 Like
#3

The problem with the value 1 as the smallest unit in the macros becomes all the more obvious when you use the comb filter, where only very small deviations (less than 1) produce sufficient deviations in the sound so that it doesn’t sound too wild, for example with pads.

#4

Strangely enough, this works with the “Pitch” value of both oscillators, but not with all other values, although ONLY superficially, as the values are not saved.

This is particularly noticeable with the cutoff, where minimal changes to the value can result in clearly audible changes to the sound.