Is there any way to display the values of e.g. the envelopes in ms and the LFO rate in Hz, instead of values between 0 and 100(%?)?
The display of the LFO rate doesn’t tell me anything about the actual frequency.
While the manual does tell me: “If the Sync LED isn’t lit, the LFO Rate can be set between 0.015 Hz (one cycle takes a bit over 66 seconds) to 100 Hz”. Nice to know, but how does it correspond to the 1-100 range in the display? It’s not percentages because then a value of 1 would correspond to 1 Hz instead of 0.015 Hz. Besides that, sometimes the steps seem a bit coarse for my liking. But that’s another issue.
For the envelope’s ADR values, maximum doesn’t tell me anything. E.g what is the maximum value of them?
I know, I should just listen to it. It’s just a preference of mine to see the actual values instead of min-max. An option in the Utility menu to switch between min-max and actual values would be greatly appreciated.