[Bug] "Preset value info" shows wrong parameter for FX reverb damping

Brute PolyBrute
#1

Hi everyone,

I think I have found a bug in the current (3.1.1) PolyBrute (12) firmware. Maybe someone can check and confirm the bug here:

One of the hidden functions is the ability to show the stored values in a patch for any knob by holding the “Preset” button and turning the knob. The display then shows the value for the “A” and “B” side that is currently stored.

But if I use this trick on the “FX reverb damping” knob, the parameter shown in the display is not “FX reverb damping” but “FX OutLevel” - which by the way is a parameter that has no knob on the panel and therefore cannot be changed to my knowledge. On my PolyBrute 12 the value is displayed always at 100% for “A” and “B”.

It would be great if somebody could have a look at this.

Best regards,
Stephan

1 Like
#2

I can confirm mine acts the same way. I can’t find anything that seems to correspond to “FX OutLevel” either, on the hardware knobs or Settings or in Polybrute Connect.

1 Like
#3

I have just reported this to the Arturia support. Thanks!

1 Like