Any Clock Out tips?

[niks.arturia]

Hi,
I’ll try to reproduce this issue asap

[liemtom]

any news or update on this topic? i want to use the clock output to start my clock dividers but also give it a stop signal at the reset in … or how to i sync up an clock divider in my eurorack with ableton

[tmoore]

There haven’t been any firmware updates since v2.0.1 in April. The release notes don’t mention anything about this.

I just tested again with my NTS-2, and I’m seeing the same behaviour as in v2.0.0. The ring stays high after I stop the transport in Ableton Live 12, even though AudioFuse Control Center shows no MIDI activity.

@niks.arturia any luck on your end? I never ended up raising a support ticket, because I assumed you were handling it. I could if it would help.

[liemtom]

any tips on wich cable to use? i got a TS eurorack cable trying to clock the clock divider but there is no signal… should i use a trs to ts cable?

[tmoore]

A TS should work if you only need the clock signal. Note that it only sends the analogue clock signal when it’s receiving a MIDI clock from a DAW or other source.

[liemtom]

unfortunatly there is nothing coming out of my clock output… also measured with a v meter but nothing… ableton is sending sync messages and its checkbox is active…

anyone else having problems getting a signal? any solutions?