June 20, 2021, 02:23:50 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Spark 1 novice - dragging patterns while maintaining paramaters  (Read 367 times)

piedle

  • Apprentice
  • *
  • Posts: 4
  • Karma: 0
Hi,

So sorry for the simple question but I can't seem to find this addressed in the manual.

So I am simply dragging a singular 16-step pattern from a singular instrument and dropping it onto its corresponding Logic Pro X track.

It copies over and I can hear the pattern fine, but it's been stripped of all its altered parameters (cutoff, panning, etc, etc...)

I'm guessing this is an obvious question - but can anyone give me the obvious answer?

Once again, please do excuse my naivety and thanks in advance!

Terrym

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1.531
  • Karma: 40
    • soundcloud.com/logicaldream
Re: Spark 1 novice - dragging patterns while maintaining paramaters
« Reply #1 on: August 15, 2019, 01:50:13 pm »
Hi, Welcome to the forum,
When you drag over the pattern to your DAW only the midi pattern is copied not the parameters  so the best way would be to make your pattern and parameters in spark then drag over the audio section into your DAW as this will be the same as spark.
TerryM
ARTURIA Tester for Keystep pro,Audiofuse range, Microfreak,Kl49mkII,DrumBrute,Spark,Analog lab3,KLE,kl88,matrix12,Semv,Beatstep,Minibrute 2,Pigments
ASC,Vcol6, Beatstep pro, VCOL7, Synclavier v.Minibrute2s

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines