July 14, 2020, 06:54:49 pm
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: MIDI Control Centre - Sequence management  (Read 328 times)

westofben

  • Apprentice
  • Apprentice
  • *
  • Posts: 40
  • Karma: 0
MIDI Control Centre - Sequence management
« on: August 31, 2019, 11:58:20 am »
MCC with KeyStep allows you to manage and program sequences etc. Will it be possible, or is it possible to do the same for the MicroFreak?

Please excuse me if I have not found this. I have not gone very deep in MCC since buying the MF. I did manage to update firmware and update the patch banks to latest but did not initially see any way to manage sequences.

Donít get me wrong, in the form factor of the MF, programming sequences is not terribly difficult, but I did enjoy developing sequences faster with the KeyStep using MCC.

westofben

  • Apprentice
  • Apprentice
  • *
  • Posts: 40
  • Karma: 0
Re: MIDI Control Centre - Sequence management
« Reply #1 on: July 06, 2020, 04:19:46 am »
Any chance of this becoming a reality?

Does anyone have suggestions for visually creating sequences, speed up workflow etc?

ShapedNoise

  • Jr. Member
  • **
  • Posts: 51
  • Karma: 0
  • Hi all!
    • Kirke Godfrey
Re: MIDI Control Centre - Sequence management
« Reply #2 on: Today at 04:09:01 am »
It would be VERY useful if simple midi files could be imported to the freak Seq via the Midi Control Center.


MCC with KeyStep allows you to manage and program sequences etc. Will it be possible, or is it possible to do the same for the MicroFreak?

Please excuse me if I have not found this. I have not gone very deep in MCC since buying the MF. I did manage to update firmware and update the patch banks to latest but did not initially see any way to manage sequences.

Donít get me wrong, in the form factor of the MF, programming sequences is not terribly difficult, but I did enjoy developing sequences faster with the KeyStep using MCC.
Stay Safe.

 

Carbonate design by Bloc
SMF 2.0.13 | SMF © 2016, Simple Machines