March 28, 2024, 07:12:57 pm
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Why does Keystep still send Start/Stop messages with Transport mode off?  (Read 1582 times)

explosiwe

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
I have my Keystep hooked up with M32 via MIDI. Every time i press play the M32 sequencer starts running, no matter if Transport mode is set to OFF or not. Why? I know i can hook it up with CV but that's not what i want in this case...

What I did notice is that when keystep is synced to an external MIDI clock source (in my case the Beatstep Pro) turning of transport mode does the job if MIDI clock source is already running.
Meaning:
I have the MIDI-out from BSP connected to MIDI-in on Keystep and MIDI-out on Keystep connected to MIDI-in on M32. Than i perform the following steps:
1: I press play on BSP and both Keystep and M32 sequencer start to run
2: I stop M32 sequencer
3: I press stop and than play on Keystep pro without activating the M32 sequencer. (when Transport settings is turned on this would cause M32 to run again)

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines