December 17, 2018, 03:46:44 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Low input from external input with eurorack modules/internal osc's  (Read 72 times)

miikka

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
Hi,

I have noticed that when i connect external eurorack oscillator-module to the external input of minibrute 2s, i got noticeably lower input volume from module when comparing to "hardwired" waveforms (behind sliders).

I tried to test this and if it was related to the eurorack-module itself in use by patching Minibrute's own oscillator sawtooth-wave to the input, but with similar results. Basically when i patch raw Sawtooth-wave to the external input and compare volumes of "hardwired" Sawtooth and one patched to the external, the external in the max is about 70% of the hardwired on the max volume.

Is this normal behavior? Are the input levels normally this low? I was thinking of Doepfer A-183-3-module as solution, but wanted to make sure before that this is normal in minibrute 2s.
 
Thanks!

 

Carbonate design by Bloc
SMF 2.0.13 | SMF © 2016, Simple Machines