December 13, 2018, 04:22:46 pm
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Sustain pedal only triggers once  (Read 246 times)

travisttk

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Sustain pedal only triggers once
« on: October 11, 2018, 03:20:45 pm »
Hey guys, I just received my Keylab essentials today and I've been trying to figure this out for couple of hours now and can't seem to find the solution.

So I realised that my Korg DS1H pedal isn't sending any signals when plugged in to the keylab. However, when I remove and plug the pedal jack into the sustain input, I see a Midi signal in the Midi control center and also it sends a signal when I press the pedal but only once. So it only works once when I remove and plug the pedal in again. Anyone has a solution to this?

Additional note: when i plug out the pedal it appears on the screen, sus-pedal val:0 and when i plug it in and press the pedal, val:127
« Last Edit: October 11, 2018, 03:22:45 pm by travisttk »

Matt Arturia

  • Administrator
  • Sr. Member
  • *****
  • Posts: 480
  • Karma: 41
Re: Sustain pedal only triggers once
« Reply #1 on: October 12, 2018, 10:46:54 am »
Hi,

Unfortunately the Korg DS1H is one of few sustain pedals that send a smaller voltage than the usual and this voltage is not on the range expected by the KeyLab Essential. So for now there is no way to make the DS1H working with our controler.
I'll warn the dev team about that but I don't know what will be done for now.

Regards,

Matthieu

travisttk

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Re: Sustain pedal only triggers once
« Reply #2 on: October 12, 2018, 02:22:41 pm »
Yeah figured I should just get another sustain pedal then. Thank you

 

Carbonate design by Bloc
SMF 2.0.13 | SMF © 2016, Simple Machines