BSP Err 0d after USB fix

[autodafe]

I have put the beatstep back together for the moment, I am waiting for new FFC connectors, then I will reopen it and re-inspect the connections better and check continuity between the capacitor, the resistor and the USB plug. I supect there could be some small short or bad connection on one of the two D+ or D- wires...

[autodafe]

I solved my issue by replacing the 2 resistors R22 and R23 using 2x 10 Ohm resistors, I connected it to my laptop and it was immediately recognized by Windows and MMC, upgraded to latest firmware....and so on...

Then I probably broke the small FFC cable I had fixed and now have the "ERR Od" again ....

waiting for replacement cables to arrive from China....
But at least now I know it's working

[autodafe]

I found this rant post regarding resistors value, somebody suggested using two identical 22 Ohm resistors, but I only had some 10Ohm lying around...and they worked perfectly ! 

[I grec]

Hi autodafe,

I solved my issue by replacing the 2 resistors R22 and R23 using 2x 10 Ohm resistors, I connected it to my laptop and it was immediately recognized by Windows and MMC, upgraded to latest firmware....and so on...

Good news!
For your information, original R22 and R23 resistors are 22 ohms resistors.

I hope everything will be ok with your replacement cable.

Regards,
Y.

[I grec]

I found this rant post regarding resistors value, somebody suggested using two identical 22 Ohm resistors, but I only had some 10Ohm lying around...and they worked perfectly ! 

Yes, it may work even without resistors but it is safer to use these resistors for signal integrity.

[autodafe]

For your information, original R22 and R23 resistors are 22 ohms resistors.

yes, I found the same info on reddit...I have plenty of SMD resistors but no 22 Ohm, 10Ohm works at the moment...
I will order some 22Ohm and then replace them ...

[autodafe]

i resurrect this post just to say that I fixed my BSP. After the 10 Ohm resistors, I ordered some new FFC cables that never arrived from China. From that moment I never stopped looking for rubbish around me. Today I found a Fax Machine in a thrash bin...Luckily it had a 30cm. FFC cable, 12 pins, I stripped it vertically and replaced the broken one. BINGO !!!