Proper Keystep MIDI Control Center settings

[flat_land_cycle]

I'm working on KeyStep setup in the MIDI Control Center.  So far no notes lower than C4 will play on my KeyStep.  I can't figure out the logic on this.


This is from the chart on Page 64 of the Manual:

Transpose Center Pitch | Full MIDI note range  | Notes above/below center transpose the sequence up/down



I have no idea what "Notes above/below center transpose the sequence up/down" means.

The Drop Box (data field) only has notes like C-1 to like C8. 

I think the problem is with what belongs in "0V MIDI Note" text box and what belongs in "Transpose Center Pitch" text box.  I have yet to find the correct combination.  I have a Moog M-32 that wants 0V for C4, in CV out mode, not MIDI.   C4 doesn't seem to work in "0V MIDI Note" field.  All help would be appreciated. 

[flat_land_cycle]

Additional info:

 All notes including Transpose lower Octaves output 0V from the PITCH out.  There are no longer negative voltages from the CV out.

[davidnull]

Mh, keystep does not output negative voltages, so you need some kind of adapter, can't you use midi instead?

[Trevor42]

The problem lies with the moog set on OV C4, thats just too high. Should be OV for CO in most Eurorack i believe.

there is a CV AT O Volt field, did you try choosing C4 there?