August 06, 2020, 12:57:16 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Program change  (Read 1425 times)

twylla23

  • Apprentice
  • Apprentice
  • *
  • Posts: 7
  • Karma: 0
Program change
« on: February 13, 2017, 02:06:26 am »
Sorry if something like this was already posted and I did not see it.
I would like to sequence pattern changes from Maschine software. I have a mio10 10 output midi out on channel 4 to the Drumbrute.
I have the midi source in Maschine preferences set to mio10 ch4  and channel 4 output. I can either sequence the individual sounds or start stop the Drumbrute sequencer. Can I have pattern 1 on the Drumbrute play in Maschines scene 1 then have pattern 2 play in Maschine scene 2 and so on? I see below velocity(in Maschine) you can add program change to the track, but this does nothing.
Sorry, I know this is partly a Maschine question too.

Valentin Arturia

  • Administrator
  • Full Member
  • *****
  • Posts: 148
  • Karma: 28
Re: Program change
« Reply #1 on: February 13, 2017, 01:39:02 pm »
Hi twylla23,

you can change pattern using MIDI message. You'll find more info here

https://www.arturia.com/faq/utilization/drumbrute-general-questions

in this section : Can I change Song / Bank / Pattern from a MIDI message ?

Best

twylla23

  • Apprentice
  • Apprentice
  • *
  • Posts: 7
  • Karma: 0
Re: Program change
« Reply #2 on: February 15, 2017, 05:34:46 am »
Thank you. I had found that before I posted. I just have no clue how to send these midi messages from Maschine software.

 

Carbonate design by Bloc
SMF 2.0.13 | SMF © 2016, Simple Machines