April 03, 2020, 10:33:38 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Minibrute Firmware Failure - All solutions attempted  (Read 640 times)

szlafarski

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Minibrute Firmware Failure - All solutions attempted
« on: November 12, 2016, 12:57:43 am »
Hey there!

I've been searching the web all day and this forum has come up often.

I recently acquired a Minibrute that had a malfunctioning arpeggiator switch that was stuck in Up mode when set to Up/Down and Random. I was told to update the firmware instead.

I downloaded the newest firmware, connected the device, and attempted to install. The update froze partway through and failed. I attempted to reboot and got the 5 LEDs on the octave switches lit up. I tried running the firmware again but it wouldn't see the device this time.

So, I followed the steps of powering down, holding the octave switches, and trying again. Still nothing. I tried this dozens of times and nothing has worked.

I tried finding the older Firmware in case there was an issue with making the jump. So, I downloaded the older version of Brute Connection and the Firmware (1.0.2) and tried the same thing. No luck. I followed the steps again to click cancel when the device could not connect/be seen, attempted to manually upload the firmware by clicking the Firmware tab and the update button. Nothing.

I tried different cables, different ports and different computers. Nothing works. I'm currently attempting to run on OSX El Capitan/10.11.6

I've even tried rebooting after removing the device from power, with and without holding the buttons. At one point I managed to get it to power on with a single LED lit (the LED for -1 octave) but even still, nothing worked.

As it stands, the device is totally unresponsive. No sound, no other LED response or key response.

szlafarski

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Re: Minibrute Firmware Failure - All solutions attempted
« Reply #1 on: November 12, 2016, 07:07:02 pm »
UPDATE:

I've attempted the "stronger charger/power supply" trick. No luck.

Last attempt, the first LED of the 5 was lit. Waited 2 hours, no progress. Firmware update still stuck on 0%.

Attempted again. This time, the second LED of the 5 lit up. Still no progress with the firmware updater.

 

Carbonate design by Bloc
SMF 2.0.13 | SMF © 2016, Simple Machines