September 27, 2021, 02:53:09 pm
Welcome, Guest. Please login or register.
Did you miss your activation email

Arturia Forums

Author Topic: Couple of issues with arpeggiator and output, would this fix work?  (Read 942 times)


  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Couple of issues with my minibrute:

1. Main output is dead.
2. Headphone output works when turned all the way up. Then a little bit of sound comes out. But barely.
3. Arpeggiator LED is always flashing, even if arpeggiator switch is off/hold.

Flashed to newest firmware. All cables are secure and fastened in. Resoldered the main output jack pads (they were wiggling loose) - still no sound. I am thinking the TL074CD op amp (U606A on the board) is dead.

Not sure why the arpeggiator always blinks. It at least works though and cycles through on/off/hold.

Would a new connector board fix these issues? It would have a new op amp and jacks, but whatever broke the arpeggiator might not be fixed.



Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines