March 28, 2024, 08:36:17 pm
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Rotary controllers not mapped correctly  (Read 2400 times)

simonc123

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Rotary controllers not mapped correctly
« on: December 23, 2015, 01:08:48 pm »
Hi, I'm new here, so apologies if this has been covered before.

I've just bought a Keylab 49 BE and it works fine with the VCollection synths running stand alone.

However, if I run the synths via Analog Lab the Keylab rotary controllers are off set as follows:

Keylab Controller 1 - mapped to Analog Lab Controller 2
KL C2 - mapped to AL C3
KL C3 - mapped to AL C4
KL C4 - mapped to AL C4 (note doubling up)
KL C5 - mapped to AL C5

I'm using the factory default mappings running on an iMac.

Any ideas please?

Cheers.

ben arturia

  • Administrator
  • Hero Member
  • *****
  • Posts: 822
  • Karma: 31
Re: Rotary controllers not mapped correctly
« Reply #1 on: December 23, 2015, 03:44:04 pm »
Hi simonc123,

I'm not sure to understand your pb here.
Do you mean that knob 2 is mapped on GUI knob 3 ?

Could you try to reboot your kl while pressing oct + and - in order to reset the kl the factory settings ?
.......testing.......

simonc123

  • Newbie
  • *
  • Posts: 2
  • Karma: 0
Re: Rotary controllers not mapped correctly
« Reply #2 on: January 04, 2016, 05:25:33 pm »
I re-assigned the controllers manually and that worked  :)

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines