December 03, 2020, 11:24:59 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Waveform volume on MiniBrute different from MicroBrute?  (Read 1120 times)

Old_School

  • Jr. Member
  • **
  • Posts: 76
  • Karma: 1
Waveform volume on MiniBrute different from MicroBrute?
« on: September 30, 2015, 08:00:36 am »
I was hearing about how on the MiniBrute if you push the sliders past halfway mark the sound gets overdriven however on mine I really get no difference past the halfway mark. Not even a volume increase. Now, I just bought a MicroBrute and I definitely hear a difference when you turn the volume knobs of the waveforms past mid position. So I'm wondering if what I get volume/sound wise from the MicroBrute when turning up the waveform volume knobs is what I should be getting on the MiniBrute when I push the sliders up. As it stands now, it's a big difference between the two synths.

tertior

  • Full Member
  • ***
  • Posts: 168
  • Karma: 7
Re: Waveform volume on MiniBrute different from MicroBrute?
« Reply #1 on: September 30, 2015, 11:47:33 am »
Perhaps because the Metalizer or there was a change  ;)

Old_School

  • Jr. Member
  • **
  • Posts: 76
  • Karma: 1
Re: Waveform volume on MiniBrute different from MicroBrute?
« Reply #2 on: September 30, 2015, 04:13:43 pm »
I'm just curious if anyone else gets a volume increase and eventually an overdriven sound when pushing the waveform sliders past halfway mark. If so my MiniBrute may be defective.

Foghorn

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
Re: Waveform volume on MiniBrute different from MicroBrute?
« Reply #3 on: October 30, 2015, 10:06:38 pm »
Old_School,
The change is not always all that obvious.
If you run it in low pass filter with cutoff @ 1/4 to 1/2 and turn up the resonance to 1/2 to 3/4 it is much more easily heard.
This you tube video shows it well.
Just google "Arturia MiniBrute Tricks and Tips by Fluxwithit" I did not want to post a link directly.

Foghorn
I get my control voltages from electrodes on my skull.
Now where could I get the gate signals from?

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines