January 20, 2021, 11:07:02 pm
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Bug Report: Minibrute SE got stuck in 'hold' mode  (Read 1978 times)

zedius

  • Full Member
  • ***
  • Posts: 154
  • Karma: 9
Bug Report: Minibrute SE got stuck in 'hold' mode
« on: April 17, 2015, 09:11:31 pm »
The Minibrute SE sequencer has 2 Sequencer modes - 'Note On' and 'Hold'. I had my minibrute in 'Note On' mode, then at some point it switched itself over to 'Hold' mode. Opening the Minibrute Software editor, changing the sequencer mode had no effect when trying to change this back to 'Note On' mode. The solution was to reload my firmware.

Has anyone else experienced this? I can only think it was due to some midi noise from a midi feedback loop I experienced, but that would be amazing for it to accidentally receive the perfect message to change that mode and I was surprised that I could not fix it with the software.

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines