Analog factory 61 keyboard as a controller for other softsynths.

[kim olesen]

Not all synths have the same controller changes assigned to eg cutoff and resonance etc.  Is it possible to store different assigner setups in the keyboard? Lets say i want one controller setup for logics es1, another for tal-bassline and so forth. How do i store these different assigner setups so i can recall them easily?

[Manuel]

Yes it is. check out this thread here! You can store up to ten different configurations directly to the keyboard and you can export as much differnt configuration settings as you want from the MCC to your harddrive and load them everytime.

Be careful, there are still a few bugs in the firmware! One is, that the SETUP mode may not work proper as the values for the CATEGORY- and PRESET-encoders, as well as for the SNAPSHOT-buttons should be changed to standard settings when you start SETUP mode.

It's a little bit a p.i.t.a....

[kim olesen]

Thanks Manuel :-) Will try tomorrow (on gig right now)