March 28, 2024, 12:22:22 pm
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Sorry, yet another basic programming question.  (Read 4046 times)

rjt

  • Apprentice
  • Apprentice
  • *
  • Posts: 21
  • Karma: 0
Sorry, yet another basic programming question.
« on: April 09, 2007, 02:30:19 am »
Well, every time I have a lot of time off of work, I mess around with programming.  Been working too much lately!

1) I do program with the manual in front of me
2) I did a search on the forum .... but my question remains:

What exactly does Mod. Mix in the controllers section do?  Either telling me or pointing me to the correct page of the manual (English) would be VERY helpful and much appreciated.

TIA
Never wrestle in the mud with a pig--
You both get dirty and the pig likes it.

rjt

  • Apprentice
  • Apprentice
  • *
  • Posts: 21
  • Karma: 0
Sorry, yet another basic programming question.
« Reply #1 on: April 09, 2007, 04:45:15 am »
NEvermind...this seems to be similar to the questions I asked earlier.  Figured it out with a bit more experimentation and reading (I think it was page 6) of an old Mini-Mg Manual.

Thanks!
Never wrestle in the mud with a pig--
You both get dirty and the pig likes it.

zahzahtron

  • Apprentice
  • Apprentice
  • *
  • Posts: 7
  • Karma: 1
Re: Sorry, yet another basic programming question.
« Reply #2 on: August 18, 2008, 12:46:16 am »
Mod Mix in the Controllers section let's you balance the modulation source between OSC3 (however you may have OSC3 set up) and the Noise source. So, for example, you can use the knob to mix ("morph") between a traditional vibrato "woo, woo, woo" controlled by OSC3 to a scribbled up scrabbly noise using the Noise as a modulation source, or any amount between the two.

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines