October 20, 2019, 11:10:18 am
Welcome, Guest. Please login or register.
Did you miss your activation email

Arturia Forums

Author Topic: Minilab stopped working entirely  (Read 2027 times)


  • Newbie
  • *
  • Posts: 1
  • Karma: 0
Minilab stopped working entirely
« on: July 30, 2013, 05:28:30 am »
Hi all

I purchased my minilab two months ago. Everything was working fine until recently. When I plug in the minilab not only does it not turn on but I get this message saying "Because a USB device was drawing too much power from your computer, one of more of your USB devices have been disabled" (even with nothing else plugged in).
I guess it must be the usb port that is faulty, though I don't recall ever being too rough with it or dropping it. I was wondering if anyone has had this experience or know of good resources so that I can fix the usb port myself.




  • Hero Member
  • Hero Member
  • *****
  • Posts: 625
  • Karma: 48
Re: Minilab stopped working entirely
« Reply #1 on: August 19, 2013, 01:41:58 pm »
Are you use it as a "USB 1" or "USB 2" with your computer?
However, try it with several computers.
If still a problem, you can try to use another USB cable.


Carbonate design by Bloc
SMF 2.0.13 | SMF © 2016, Simple Machines