November 29, 2022, 02:06:53 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Sticky nobs  (Read 708 times)

Mandelscape36

  • Newbie
  • *
  • Posts: 1
  • Karma: 1
Sticky nobs
« on: August 19, 2022, 10:14:42 pm »
So apparently the design decision to use rubber coated nobs by Arturia was a Booboo.
The rubber just melts and starts to gather hair and gunk.
So I just spent a whole afternoon pulling off the nobs and cleaning them w 91%alcohol.

They are all nice and clean now shiny and beautiful  again.
Make sure you are outside to do this.
Just pull all of the nobs off and rub them with a wash rag.
I used alcohol but dish soap might work too.
You have to clean the slider nobs also.

I consider this just basic maintenance.
Ill have to do this to my microbrute also but they are not sticky yet.

BE CAREFUL putting the nobs back on.
I put one on wrong and then it was loose forever, I just put a drop of elmers in the nob and it held.

Have fun, make sure you use alcohol OUTSIDE!

MajorFubar

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1.067
  • Karma: 30
Re: Sticky nobs
« Reply #1 on: August 22, 2022, 11:23:59 am »
Great tip, thx for posting
2022 Apple Studio Max 32/32/2TB Monterey 2020 MBA 8/8/512GB Monterey V Collection 9 Analog Lab 4 + 5 KeyLab 88 KeyStep

LeeW

  • Guest
Re: Sticky nobs
« Reply #2 on: November 22, 2022, 11:34:03 am »
HI ,
I emailed Arturia as my white Microbrute SE has the "knob rot"; they will sell me replacement knobs. For all 20 knobs it will cost me 75!! and 5 each for the pitch and mod wheels
They will be the same knobs so the issue of sticky knobs will reappear in time on the new knobs.
So not ideal.

I was wondering if the keystep37 knobs fit the micro brute as they are the fully plastic non rubberised type?
Personally I don't care what colour or shape the knobs are as long as i can replace these old ones.

Koshdukai

  • Beta-testers
  • Hero Member
  • *
  • Posts: 651
  • Karma: 30
Re: Sticky nobs
« Reply #3 on: November 23, 2022, 09:05:01 am »
The Keystep ones are OK after all this time (since release).

But you could wash/rub the knobs with isopropyl alcohol, that's how I fixed the issue on the knobs and side panels of the OG Minibrute, an Audio interface (Propellerhead Balance) and a Nektar Sustain pedal.
« Last Edit: November 23, 2022, 09:07:15 am by Koshdukai »

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines