January 29, 2022, 02:16:06 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Broken VCO1 only on Square Wave  (Read 240 times)

arthur_antoine

  • Apprentice
  • *
  • Posts: 4
  • Karma: 0
Broken VCO1 only on Square Wave
« on: December 23, 2021, 02:01:38 pm »
When i play an init patch, six notes in a row with a square on VCO1, the 3rd note doesnt play...!
The other waveforms work fine.

I calibrated everything several times, sometimes with success and sometimes with a timeout failure.
Downgraded the firmware to 1. But all with the same outcome, no 3rd voice being played.
So i am afraid this is a hardware issue  :'(

Has anyone experienced this too?

pierresilence

  • Apprentice
  • *
  • Posts: 3
  • Karma: 0
Re: Broken VCO1 only on Square Wave
« Reply #1 on: December 25, 2021, 08:47:26 am »
Hi, I have same problem a will back the instrument to the dealer.

arthur_antoine

  • Apprentice
  • *
  • Posts: 4
  • Karma: 0
Re: Broken VCO1 only on Square Wave
« Reply #2 on: January 14, 2022, 10:59:34 am »
I've had contact with support during the holidays to perform some settings and enter debug mode. They were of great help and very kind. It confirmed that 1 voice was not working properIy. And I almost sent it back for repair because the problem persisted. But meanwhile i tried to get the autotuning program to finish without errors. Again and again. And after a few days of not using it, i powered it up and the tuning finished correctly and the problem disappeared! :-)
So it looked like a software issue and not a hardware problem.

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines