February 08, 2023, 07:44:25 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: MCC doesn't connect with my Keylab Essential 61 (Mac)  (Read 578 times)

vespina

  • Apprentice
  • *
  • Posts: 10
  • Karma: 0
MCC doesn't connect with my Keylab Essential 61 (Mac)
« on: September 26, 2022, 09:44:43 pm »
I just received my new Keylab essential today and installed MCC successfully and ran it once without problems. I then updated the controller with the latest firmware (1.1.10) and exited MCC.  A few minutes later I tried to run MCC again but now it doesn't connect with the controller.  Any ideas about what could be the problem ? 

vespina

  • Apprentice
  • *
  • Posts: 10
  • Karma: 0
Re: MCC doesn't connect with my Keylab Essential 61 (Mac)
« Reply #1 on: September 27, 2022, 03:30:53 pm »
Just restarted my computer and now everything is working ok again.

vespina

  • Apprentice
  • *
  • Posts: 10
  • Karma: 0
Re: MCC doesn't connect with my Keylab Essential 61 (Mac)
« Reply #2 on: November 04, 2022, 04:38:39 pm »
Just for anyone arriving here with the same issue, the problem is a incompatibility between MCC and ASC for Mac, in their current versions.  If you install any of them individually, they will work as expected... but if you install BOTH, then only the last one installed will work.  Arturia is already notified about this problem and it should be fixed (hopefully) in the next versions of MCC and ASC.

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines