December 09, 2021, 02:13:47 pm
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Is it possible to save a default gate value?  (Read 184 times)

bronco

  • Apprentice
  • *
  • Posts: 3
  • Karma: 0
Is it possible to save a default gate value?
« on: October 15, 2021, 09:17:29 pm »
KSP seems to have a long default gate value that kind of makes it impossible to using in while live performing.
I need it to be set to the shortest gate value for it to work for me but just can't get it to work.
On Arturia webpage it says:
--------------------------
Can I change the default Gate/Velocity values when entering steps in Quick edit mode?
Yes. Whenever you create a step by holding a note, pressing a step to assign it to and change the Gate/Velocity values,
these values become the new default values and will be remembered when you create another step and be applied to it.

-------------------------
Tried that, but if you want to change on the fly from time divison 1/16 to 1/32 it seems to default to long values again.
So, is there a way to make the shortest gate value as a default?

cnps

  • Full Member
  • ***
  • Posts: 135
  • Karma: -1
Re: Is it possible to save a default gate value?
« Reply #1 on: October 28, 2021, 09:51:12 pm »
KSP seems to have a long default gate value that kind of makes it impossible to using in while live performing.
I need it to be set to the shortest gate value for it to work for me but just can't get it to work.
On Arturia webpage it says:
--------------------------
Can I change the default Gate/Velocity values when entering steps in Quick edit mode?
Yes. Whenever you create a step by holding a note, pressing a step to assign it to and change the Gate/Velocity values,
these values become the new default values and will be remembered when you create another step and be applied to it.

-------------------------
Tried that, but if you want to change on the fly from time divison 1/16 to 1/32 it seems to default to long values again.
So, is there a way to make the shortest gate value as a default?

Following.

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines