December 09, 2022, 05:17:22 am
Welcome, Guest. Please login or register.
Did you miss your activation email

Arturia Forums

Author Topic: VCA ENV difference  (Read 824 times)

  • Apprentice
  • *
  • Posts: 30
  • Karma: 0
VCA ENV difference
« on: July 22, 2021, 01:14:50 pm »
I noticed something with my Polybrute that seemed odd (to me) but might be completely normal. So I wanted to see if other people had the same on their synth too.
Initialize a patch, then set the VCA ENV sustain to min and the decay to about 25%. You should hear some sort of pluck sound. Now toggle VCO1 filter routing between Steiner and Ladder. For me, the Steiner filter has a much shorter envelope than the Ladder.
Does anyone else have this?  :)


  • Jr. Member
  • **
  • Posts: 97
  • Karma: 1
Re: VCA ENV difference
« Reply #1 on: November 12, 2021, 06:14:19 am »
It's been a while, but I can confirm.

But possible that levels on filters are different making longer time until decay is done, not sure.

I also looked into setting regarding VCA curve settings, and difference remain for decay. depending on filter.

About attack curves I can sense no difference at all if using either filter, but no difference regarding curve selected either.

So will report to support regarding this if a firmware is about to be updated.
Almost a year since last now.

Could be a thing that should be part of some calibration when doing All, and VCA is included.


Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines