September 21, 2021, 12:11:06 pm
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Minibrute Filter selector and sound problems  (Read 180 times)

T1-10r

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
Minibrute Filter selector and sound problems
« on: July 02, 2021, 04:16:16 pm »
Hi all,  I'm new to this forum.   I've had my minibrute for several years now, but it has sat silent for about three years.  I started to play with it again and I found a few issues. 
First the selector wont allow me to switch filter types and appears to be stuck on HP filter.  Is this issue a matter of replacing the POT or does this run deeper?  If its the POT, can someone direct me to a source or even a product code to replace the pot?

Secondly I had Keyboard issues and solved that by reconnecting the ribbon cable to the main board.

Thirdly, now that my keyboard is working, I can get sound but through my headphone output and it is very weak except: 1) when i make the filter resonate and 2) when i set the AMP in the LFO section to full negative, I can boost the volume but still not full sound. 
The main output is worse than the phone output and I can only get sound when the LFO section AMP is set to full negative.  Everything else works fine, although I haven't checked the CV outputs.  To me, it seems like my amp is fried. 

If anyone has some helpful input to fix these problems, I will greatly appreciate it.

Thank you

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines