May 16, 2021, 10:41:21 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Shape knob resets to some random value in Sequencer mode  (Read 91 times)

Laion

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
Shape knob resets to some random value in Sequencer mode
« on: April 05, 2021, 05:22:49 pm »
Hi there!

I experience a strange bug when on Sequencer mode - the "Shape" amount will reset to some value 2 seconds after I tweaked it. I don't have any modulation routed to the Shape knob, and it happens independently from the synth engine I'm using. Would you please know how to overcome this issue?

Thanks a lot!!
Best regards,
Lionel

PS: I'm on firmware 3.0

Amaethron

  • Apprentice
  • *
  • Posts: 28
  • Karma: 0
Re: Shape knob resets to some random value in Sequencer mode
« Reply #1 on: April 13, 2021, 02:40:24 pm »
Are you sure that the MOD sequence isn't running? You can check that with the "Oct | Mod" button and the four LEDs besides it. And you can clear the moculation sequence by holding  "Oct | Mod" + "hold" from the sequencer (very left button)

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines