April 12, 2021, 02:16:41 am
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Scratchy cutoff pot - replacement pot ?  (Read 335 times)

dave the butcher

  • Apprentice
  • *
  • Posts: 6
  • Karma: 0
Scratchy cutoff pot - replacement pot ?
« on: March 04, 2021, 12:43:50 pm »
Hi everybody,
I have a scratchy cutoff poti and was wondering which pot was the right for replacement, i am planning to replace it myself since i'm a rather experienced diy-er. Any Ideas? Thanks in advance!

rynlblnc

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
Re: Scratchy cutoff pot - replacement pot ?
« Reply #1 on: March 22, 2021, 08:42:48 pm »
I am having the same issue but i'm not a diy'er and hoping to find support from the manufacturer but not sure how to go about that

knerps

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
Re: Scratchy cutoff pot - replacement pot ?
« Reply #2 on: March 28, 2021, 03:50:51 pm »
I have same cut off noise problem also osc 2 tuning is erratic and noisey
any suggestions?
« Last Edit: March 28, 2021, 03:56:57 pm by knerps »

MadHatStrider

  • Apprentice
  • *
  • Posts: 3
  • Karma: 0
Re: Scratchy cutoff pot - replacement pot ?
« Reply #3 on: March 29, 2021, 10:12:22 pm »
I have the exact same issues.
Crackling cutoff pot
Rustling resonance and metalizer pot
and erratic and noisy osc 2 tune pot...

I am rellay frustrated by now.
I sent the unit back to arturia and they fixed everything....except that the resonance started to crackle again. Its really a pain.
I really enjoy the arturia stuff. Microbrute and Drumbrute doing their thing without any hustle till this day, but the mb 2 cause me some nervs.

Back to the topic. Maybe their is a bad production series of pots? Arturia couldnt provide me with evident infos of the problem till now.
I hope they send me  a replacement board or something like that, because i am tired of sending it back by now.





 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines