February 05, 2023, 02:19:28 pm
Welcome, Guest. Please login or register.
Did you miss your activation email
News:

Arturia Forums



Author Topic: Encoder position recall - software dependent?  (Read 815 times)

Jameslondon74

  • Apprentice
  • *
  • Posts: 22
  • Karma: 0
Encoder position recall - software dependent?
« on: April 06, 2020, 01:34:54 pm »
Hi all, I'd like my encoders to turn a value without skipping the value based on where the encoder is set to at the start of the turn. Is this software dependent?
E.g. I go to turn Cutoff, and because the encoder was previously turned all the way to the left on a different program, it immediately skips 'cutoff' to the far left setting.
This really screws up my performances, so I was wondering how to change it to make the encoders pickup / detect where the setting is and simply match it and turn FROM that value, instead of skipping.
Thanks.

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines