LFO 1 Not working

[Chromat1c]

Strange, I cannot get any action at all from LFO 1 after doing the update. Nothing.

[Lunatic Sound]

There is a step in the update where you had to shut down the MxB and power it back on and if you missed that, some of the subboards would not get updated. There is a way to check the subboards firmware, Dr Justice described it somewhere here...

[endreola]

The link to the post below describes how to check the versions that each MxB module is running (albeit version v1.1 is referenced & not v2).

https://forum.arturia.com/index.php?topic=92706.msg148922#msg148922

If a module in your MxB did not get upgraded then you can simply upgrade just that module directly, also mentioned in that post.  Holding both REC + 1/8 note buttons in the SEQ section will force the LFO module to reload its firmware.

Cheers