Arturia Forums
Software Instruments => DX7 V => DX7 V - Technical Issues => Topic started by: jkashner on September 11, 2019, 07:11:18 am
-
What is the easiest/simplest way to automate a DX7 V L<->R stereo Pan with an LFO 2 modulator?
I have read and reviewed the current DX7 V manual, (and used DX7 V extensively quite a long time ago), and have also tried several intuitive ways to automate an L<->R Stereo Pan using LFO 2.
However, I have found nothing explicit in the manual about how to do this, and my own efforts have also not yielded my desired result.
Could you please provide a brief outline of the steps that are required to accomplish this in a reply to this post?
I recall that this was very easy to do (in my distant past) when I was a more frequent user of DX7 V.
thanks in advance and best regards, jim
-
Hey,
For this you must head to the MOD tab and assign LFO 2 to all the Operators that are Carrier in the algorithm that is used.
Make sure that the total amplitude of LFO 2 is not assigned to the mod wheel, like it's the case on many preset. If it's the case you have to set the Mod Wheel -> LFO 2 amp modulation amount to 0.
I attached a screenshot that show the process a bit, as well as a preset in which I set up what described above
Hope this help !
Victor