Arturia Forums
Hardware Sequencers => BeatStep Pro => BeatStep Pro - Technical Issues => Topic started by: theguvnor on August 25, 2019, 08:09:37 am
-
Hi,
I am having skipping problems with a number of the encoders on my Beatstep Pro. The values are skipping all over the place when a few encoders are rotated, and sometimes glitching when left at certain positions. Some of the faulty encoders are those used to set pitch (30-detent ones) and some are the non-detent type (Swing and Rate/Fine encoders).
It is definitely a hardware issue, as my other Beatstep Pro with the same same Firmware version works fine.
Do any of you know high quality replacement part numbers for these (Bourns/ALPS) for purchasing online?
Thanks!
-
Hi,
I am having skipping problems with a number of the encoders on my Beatstep Pro. The values are skipping all over the place when a few encoders are rotated, and sometimes glitching when left at certain positions. Some of the faulty encoders are those used to set pitch (30-detent ones) and some are the non-detent type (Swing and Rate/Fine encoders).
It is definitely a hardware issue, as my other Beatstep Pro with the same same Firmware version works fine.
Do any of you know high quality replacement part numbers for these (Bourns/ALPS) for purchasing online?
Thanks!
Are you sure it is not a problem of too high touch sensitivity?. Some units have it, some don't, so the same firmware could act differently. I have one very sensitive unit and it was hard to use until I fixed it following the published procedure.
Jose