Arturia Forums
Audio => AudioFuse => AudioFuse - Technical Issues => Topic started by: macr0 on July 13, 2019, 05:50:43 am
-
Hi there,
I think this may be a noob thing that I just can't figure out.
I have a drum machine that I can hear in stereo when I use my headphones.
I have the L/R outputs of the drum machine going into input 1 and 2 respectively.
Monitoring via headphones or speakers via the audiofuse, and through my DAW the signal always sums to mono. I don't have mono mode selected anywhere and I have experimented with the PAD, INST etc buttons with no change.
What am I doing wrong?
Thank you :)
-
Hi What Daw are you using ? The input channel must be stereo with both channel 1 and 2 selected for the stereo input also check your Panning
-
Hello,
I am a newbie too, I faced the same problem (with or without AudioFuse connected to my computer).
I found the solution :
In the "Direct Monitoring Mix" section of AudioFuse Control Center software, move the "Pan" knob of Input 1 to completely to the left and the "Pan" knob of Input 2 to completely to the right.
Pan knob is the circle knob at the top of input 1, 2, 3, 4.... sections.
Do the same for Input 3 and 4, if you need to record them in stereo too.
Denony