Arturia Forums
Hardware Instruments => MatrixBrute => MatrixBrute - Technical Issues => Topic started by: Chromat1c on June 12, 2019, 08:24:58 pm
-
Did a tune and got this message after a while "tuning failed". Tried three times. I used my strobe tuner to see how out it was and it was sharp by a 1/4 tone.
It has been on for a good hour. Ill give it a reboot.
-
Check that you're not sending CV to any of the CV inputs for oscillator pitch. If you do send any CV to those inputs during a boot up or autotune it will throw it off.
-
Yeah nothing in my CV unless its a short on my CV patchbay or cable. To be honest I fell asleep after I posted so will have another go in a bit.
Imagine you were playing live and did a tune but did not notice the fail message. The message just scrolls once then disappears.
-
Old post lol
you were nearly right it was a short on my CV patch bay.
-
Awesome!