Arturia Forums
Hardware Instruments => DrumBrute => DrumBrute - Technical Issues => Topic started by: zeitwand on October 16, 2018, 01:44:29 pm
-
Hi, ive get the new Arturia Drum Brute Synthesizer, i want to do something. I put the Headphone on but only blinking some lamps and no Sound output to the Headphones. Nothing :( What can i do?
Please help, thx
-
HI zeitwand on welcome on this board.
on the DrumBrute (not the Drumbrute impact), you'll see that in rear panel, in headphones section, you have a 3.5mm socket, a 6.35mm socket to plug your headphones, and a little button labeled "level"
if you push this button, it will make this button stand out the rear panel. From there, you can set the volume of headphones output by turning it.
You'll also notice that each instrument track has it's own level knob.
hope this helps,
cheers,
ps : this post was in the wrong category, i'll move it right away.
-
hi at first, thank you for the fast replay :)
so i will try it.
is it possible to set the drumbrute in the factory settings?
::)
OMG - now the sound work - i have not believed that this is a button :) Thank You very much!
-
Hi again,
yes you can perform a factory reset by holding song/bank/ptrn while powering up the unit, but warning : it will also erase evry stored pattern.
you can then re-inject factory patterns using the Midi control center, available here :https://www.arturia.com/support/updates&manuals (https://www.arturia.com/support/updates&manuals)
cheers,
-
Many Thanks for that information :)