Arturia Forums
Hardware Instruments => MicroBrute => Topic started by: an3z on May 26, 2018, 07:10:51 pm
-
Just bought a microbrute and would like to update the firmware but I keep getting the following message in the Midi Control Center:
''There was an error during the burn process: Update failed'' (OK)
After clicking the (OK) button it gives me the following message:
''Device currently in bootloader mode. Please update firmware.''
I keep going around in circles getting these same messages every time i try to update.
Anybody have a clue how to solve this problem?
Help would be much appreciated!
Thanks!
-
I experience the same, but on a BeatStep Pro. :(
-
That message seems to appear if your using an Apple computer, try updating the firmware on a PC.
(https://forum.arturia.com/index.php?topic=91503.0)
Also, if your sequencer stops working, try putting the switch in "Play" mode while adjusting the MIDI control centre settings.
-
I have a similar issue, I've updated the micro, but it still says a new version is available... I keep updating, but it won't install the newer version... that is available.