Arturia Forums
Software Instruments => Buchla Easel V => Buchla Easel V - Technical Issues => Topic started by: RapierApe on January 17, 2018, 10:48:21 pm
-
Hi all. Anyone else encountering jumpy knobs using the Easel in standalone mode and with a minilab mk2? Usually when I load a new preset and I turn a knob the value just shoots straight up or down instead of gradually. After that first round it typically resolves itself...sometimes...every so often if I haven't adjusted a slider after a bit it will do the same thing. I've searched prior and haven't found much help regarding music easel in itself and usually regarding programs like Ableton or Analog Lab. Everything for me runs fine on Analog Lab, haven't messed much with Ableton though. Thoughts? Suggestions? Comments?
I've also touch based with customer support but haven't really gotten much helpful answers other than the fact that the midi values are running normal...kind of a worry too since it seems like jumpy knobs are a common issue and sounds like a lot of people just return
-
Hi RapierApe, and welcome on this board.
Sorry you're encountering this issue.
The reason is because on preset loading, GUI knobs and sliders values are not sent to the minilab mkii, which leads to jumps when first tweaking any linked knob.
Please note that when using analog lab 3, Values are sent to controller on preset loading.
Time to work on a solution on a future update.
Sorry for the inconvenience,
best,
-
Ah, ok. Is there an ETA for an update?