Arturia Forums

Hardware Instruments => MiniBrute => Topic started by: Gornvix on August 31, 2017, 05:45:12 pm

Title: Which cable to connect CV input in the MiniBrute to a Moog CP-251?
Post by: Gornvix on August 31, 2017, 05:45:12 pm

Hi,

I'm guessing that I'll need a 1/8" mono mini jack in the MiniBrute connecting to a 3/4" mono jack in the Moog.  Is the voltage safe for both units?

Update
It looks like I guessed right, although I read that the MiniBrute outputs up to 10 volts which is too much for the Moog.  Connecting the other way around (Moog to MiniBrute) is OK, but possibly lacking the whole voltage range?

Title: Re: Which cable to connect CV input in the MiniBrute to a Moog CP-251?
Post by: Beesriwara on September 06, 2018, 10:57:33 am

Read this in a lot. It's a story I have not known before. After reading it, it gained new knowledge.