Arturia Forums

Hardware Instruments => DrumBrute => DrumBrute - General discussions => Topic started by: twylla23 on February 13, 2017, 02:06:26 am

Title: Program change
Post by: twylla23 on February 13, 2017, 02:06:26 am

Sorry if something like this was already posted and I did not see it.
I would like to sequence pattern changes from Maschine software. I have a mio10 10 output midi out on channel 4 to the Drumbrute.
I have the midi source in Maschine preferences set to mio10 ch4  and channel 4 output. I can either sequence the individual sounds or start stop the Drumbrute sequencer. Can I have pattern 1 on the Drumbrute play in Maschines scene 1 then have pattern 2 play in Maschine scene 2 and so on? I see below velocity(in Maschine) you can add program change to the track, but this does nothing.
Sorry, I know this is partly a Maschine question too.

Title: Re: Program change
Post by: Valentin Arturia on February 13, 2017, 01:39:02 pm

Hi twylla23,

you can change pattern using MIDI message. You'll find more info here

https://www.arturia.com/faq/utilization/drumbrute-general-questions

in this section : Can I change Song / Bank / Pattern from a MIDI message ?

Best

Title: Re: Program change
Post by: twylla23 on February 15, 2017, 05:34:46 am

Thank you. I had found that before I posted. I just have no clue how to send these midi messages from Maschine software.