Arturia Forums
Software Instruments => Mini V 3 => Mini V 3 - Technical Issues => Topic started by: LBH on December 14, 2016, 08:23:41 pm
-
The output in Mini V3 is too low.
I like that a presets output is'nt to high. But as there is a difference when - especially when using softclip - in the sound relative to the OSC level for a waveform, the the possible total output is way too low.
If i set a output that should be O db, then it's around -12 db and when softvlip is on around -18 db.
Even if i have 3 OSC's set at +13.86 db (Fully up) and the main volume like wise, then i only reach at most around 0 db with softclipping on and around -10 db when Softclipping is on.
This has an impact on the sound. Especially when using softclipping. Arturia pleasemake it possible to raise the total output level. I can imagine it's about the main output. (But please don't male the levels for the excisting presets louder. They have to be corrected/ adapted.)
I use Studio One 3. Also in stand alone the putput seems too low.
Can anyone confirm the output is too low in other DAW's too?
Edit: I forgot to say, that the output problem gets even bigger when raising the Emphasis. Up to around -12 db lower output when using emphasis.
-
Yes, output is too low. Always need to put an Utility (ableton) to raise the levels.
-
Thanks for confirming waltercruz.
i think it's important to look at the main output for this, because of the consideration to the Softclip, like i decribed in my first post.