Arturia Forums

V Collection - Legacy versions => Jup-8 V3 => Jup-8 V3 - Technical Issues => Topic started by: Wookiee on December 10, 2016, 06:00:44 pm

Title: Jup 8 not saving FX changes to patches.
Post by: Wookiee on December 10, 2016, 06:00:44 pm
I have taken a patch within the Jup 8 and turned off the echo FX and saved the patch to a different name however whenever I reload the project the patch has the echo FX enabled

This is the FX shown in the Patch section of the FX below the Voice section of the FX.

Anyone else seeing this.
Title: Re: Jup 8 not saving FX changes to patches.
Post by: LBH on December 10, 2016, 07:30:52 pm
Yes as plug-in in a project then i can confirm  if you only switch off a fx using the on/ off (bypass) button then the effects is on when you load the project again.

Is this a bug? It could be as the setting is saved in the preset. If you select the preset again, then the change will be there.
If you just save the edit with the DAW without saving the preset it's also the same.

It's the same with factory presets. All presets, that's saved with the fx off is allways on when opening a DAW project it looks like. That mean if you use one of those factory presets in a DAW project, then it's wrong when you reload the project.
So this must be a a bug Arturia.

In case it's DAW related i use Studio One 3.

If you turn the fx off by setting it to "No Effect", then the change is saved with the DAW project. All seems to work then.
But that you'll have to be aware, also when using factory presets. This is not good.

Title: Re: Jup 8 not saving FX changes to patches.
Post by: Wookiee on December 10, 2016, 08:39:48 pm
Thanks for the reply, I thought that the fact that I in effect changed it from a factory preset by saving it with an alternate name in the user preset area that would resolve the preset problem.

Interestingly enough I did try a little experiment by closing my DAW (SONAR Platinum) and then reopening the DAW and project but this time I made a point of loading the patch from the user folder and it loaded correctly with the FX turned off.

As to is it a bug, I have never had a problem with SONAR loading an incorrect patch before so I suspect it may well be a bug in the Jup 8.
Title: Re: Jup 8 not saving FX changes to patches.
Post by: Wookiee on December 11, 2016, 08:24:35 pm
I have reported this.