Arturia Forums

Software Instruments => Mini V 3 => Mini V 3 - Technical Issues => Topic started by: LBH on October 15, 2016, 01:12:46 am

Title: About waveforms -MINI Vs are reversed from the original.
Post by: LBH on October 15, 2016, 01:12:46 am

Stumbled over this video https://www.youtube.com/watch?v=eiznvGj3EzM that show a Minimoog model D Saw waveform are actually a ramp down on osc 1 (and 2) even if the graphics show a ramp up. MINI V have a ramp up, so it's reversed. I know some say i don't give any difference insound. But i have allways been able to hear a difference. And i can hear adiffernce between the Saw ramp up and down in OSC 3. OSC 3 is different as there is both ramp up and down Saws, but no saw/ triangle waveform. So there the graphic show the correct saws.

Also the video show the rectangles are above 50%. MINI V have below 50% as default. Again there is a sound difference.

In MINI V it's possible to set widths of the square waveforms, but not to reverse the saw.

I suggest again the original waveforms to be default, unless other sound more like the original model D.
A way to reverse the waveforms would be fine to add too.

Also the original Triangle, saw/ tri waveform seems to be more round than MINI Vs are.
If it's possible to do in MINI V i would like that.