Arturia Forums

Harware Legacy versions => Origin => Origin Technical Issues => Topic started by: emerson70 on October 06, 2016, 09:27:29 am

Title: ORIGIN WILL NOT BOOT UP - with replacement Origin Rear
Post by: emerson70 on October 06, 2016, 09:27:29 am

My tech has installed the (new?) replacement rear board (re Case 294729), the voltage has progressed further than before (good news) - However The Origin will NOT BOOT UP (Bad news). - No screen display or encoder activity..... and NO SOUND OUT

Is there any procedure to follow, ie a factory reset ?

If the replacement board is faulty, is there a diagnostic process we could use to test the board.

Many Thanks
Simon

Title: Re: ORIGIN WILL NOT BOOT UP - with replacement Origin Rear
Post by: Philippe on October 10, 2016, 09:12:25 am

Hi Emerson,
Sorry to hear about this problem.

How are the LEDs?
If you look at the screen almost parallel to the Origin surfaces do you see a ghost image?
Can you check that the Origin is recognised as a MIDI device by your host computer?
Can you send me the logs files generated by Origin Connection when it tries to connect to your Origin?

Thx,
Philippe

Title: Re: ORIGIN WILL NOT BOOT UP - with replacement Origin Rear
Post by: d3x on August 03, 2019, 04:40:01 pm

Hello,

I see that you've had problems with your Origin some time ago.
I accidentally killed my Origin Desktop 3 weeks ago and desperately looking for a faulty one for parts.

I emailed arturia asking for the diagram but I didn't get it. So chances of repair are very low.

I was hoping to find a donor somewhere, but there is really no faulty ones on ebay or reverb.

Please let me know if you by any chance have a faulty unit and would like to sell it for parts or have access to the schematics.

Here or d3x AT wp.pl

Regards, Dex