Arturia Forums

Hardware Instruments => MiniBrute => MiniBrute SE => Topic started by: abcdef on March 31, 2016, 04:28:18 am

Title: very basic question about hooking up to computer.
Post by: abcdef on March 31, 2016, 04:28:18 am
I have an imac and want to plug my minibrute into it and use its speakers. Is that even possible? Would I use the usb cable or Midi cable?
Title: Re: very basic question about hooking up to computer.
Post by: TonyFlyingSquirrel on March 31, 2016, 04:22:01 pm
The USB cable is for editing, the midi cable sync's to other devices and allows the Minibrute to be used as a controller.

If your iMac as Audio In, or a "Mic" in port, likely a 1/8" female jack, then you may be able to get an adapted cable to do so, then go into the settings folder and make the necessary adjustments.

Other than that, an audio interface is your best bet for getting audio in/out of your iMac, then get a reasonable set of studio monitors.  Even some of the cheaper M-Audio ones translate well.
Title: Re: very basic question about hooking up to computer.
Post by: abcdef on April 01, 2016, 03:59:56 am
thanks.