Arturia Forums

V Collection - Legacy versions => Mini V => Topic started by: GS on March 26, 2016, 12:35:17 am

Title: Cycle through waveforms with one button
Post by: GS on March 26, 2016, 12:35:17 am

Hey everyone!

I am new to the forum and the Arturia universe.

I have a MIDI controller that I use to control the Minimoog V. I have run out of faders to use to control the synth, but I have a few buttons that I can assign.

I would like to assign a button to the Oscillator's Waveform select knob where each time I click the button, it goes to the next waveform. Is this possible? Is there a way to set it to do so? I cannot seem to find any information regarding this on this forum or elsewhere. I found something related but the solution was to use a knob or fader to control the waveform but I have run out of knobs and faders haha

I want to get the most out of my controller and I want to avoid using the mouse and screen as much as possible since it hinders live performance.

Hope this can be done. Thanks!

Title: Re: Cycle through waveforms with one button
Post by: LBH on March 26, 2016, 01:03:28 am

That actually depend on your controller. If you have an option on your controller to set a button to "Step" mode or perhaps even to "Toggle" mode, then it should be possible. Please refere to your controllers manual about this.
The rest is assigment as usual.