Arturia Forums

Hardware Instruments => MiniBrute => MiniBrute Technical Questions - FAQ => Topic started by: malacalups on August 14, 2015, 07:21:10 pm

Title: calibrating the mini and micro
Post by: malacalups on August 14, 2015, 07:21:10 pm
I recently got the micro in addition to the mini .

even with fine tune knob of them both at 12 o'clock , there is a slight detune causing pulsating which is fine but I cant seem to get it to unison to start with .
also there is quite a drift in the microbrute.

from reading some posts on the subject I understand that I need to use the calibration screws on the back but I didnt quite understand in which manner .

how should I go about it ?
which should I calibrate first and how ?

also there is a difference in the oscillator sliders\knobs scaling of the the two units for setting level and since they are out of tune I cant seem to find the right reference point to have them in the same volume .